Crib Design
Lose antique baby cribs with ornamental cutouts, corner posts or lead paint. The area between the slats should be not more than two-three/8 inches apart to stop infants from getting their head stuck between them. Cribs manufactured once 1974 must meet this and other strict safety standards. The corner posts should be the identical height as the tip panels or but one/sixteen of an inch over the top panels.
No cut-out areas on the headboard or foot board so a baby’s head cannot get trapped. The high rails of crib sides, in their raised position, should be a minimum of 26 inches higher than the high of the mattress support at its lowest position.
As the child can pull himself to a standing position, set and keep the mattress at its lowest position. Stop using the crib once the peak of the prime rails is less than three-fourths of the child’s height.
Mattress
The mattress should match snugly next to the crib so that there’s no gap. If 2 adult fingers can be placed between the mattress and also the crib, the mattress should be immediately replaced. Don’t use plastic packaging materials, like dry cleaning bags, as mattress covers. Plastic film will cling to children’s faces and ought to never be in or near the crib.
Put your baby to sleep on their back or facet in an exceedingly crib with a firm, flat mattress and no soft bedding underneath. Speak to your pediatrician regarding which sleeping position is best for you child.
Crib Hardware
The drop aspect(s) of the crib should require two distinct actions or a minimum force of ten pounds with one action to unleash the latch or the locks to forestall accidental unleash by the child.
The crib hardware should be checked for disengaged, broken, bent or loose pieces. Special checks should be created of the mattress support hangers and brackets thus they can not drop. The hardware and therefore the crib should be sleek and freed from sharp edges, points and rough surfaces.
Crib Accessories
Bumper pads should cover the entire within perimeter of the crib and tie or snap in place. Bumper pads ought to have at least six straps or ties and any excess length of straps or ties ought to be cut off. Bumper pads ought to never be employed in lieu of proper spacing between the slats and should be removed from the crib once the kid can pull himself to a standing position.
Teething rails that are broken ought to be mounted, replaced or removed immediately. To forestall possible entanglement, mobiles and crib gyms, that are supposed to be hung over or across the crib, should be removed when the child is five months recent or when he begins to push up onto hands and knees or can pull himself up. Keep the crib further from plastic sheets, pillows, and massive stuffed animals or toys. These will be suffocation hazards or can enable youngsters to climb out of the crib. Any cloth or vinyl items that are loose or torn should get replaced or repaired immediately.
Crib Atmosphere
Don’t place crib next to a window. Drapery and blind cords create an entanglement hazard and window screens aren’t intended to stay a kid in, only insects out. Install smoke detectors. Follow the manufacturer’s directions for placement. Check a minimum of once a month to form positive battery and smoke detector are in sensible working condition.
storkcraft baby furniture, changing tables for babies & rumble tuff changing pad